How To Install Chevy Bowtie Center Cap Decals
WEATHER WARNING
The temperature that you install your decals in is the most critical element. Temperatures must be between 50°F to 90°F.
The weather that the decals are exposed to cannot go below 50 degrees for 5-6 days. This is due to the water used during the install. The time is needed to allow the water between the decal and emblem to completely evaporate. There may be bubbles in your decal until the water has fully evaporated.
For more details about proper temperatures and weather conditions, click here.
Clean Center Caps
Thoroughly clean your vehicle's center caps with warm, soapy water and a lint-free cloth. Make sure to spend extra time cleaning the crevices and edges. Assure your center caps are free of any dirt, grime, or grease.
Failure to clean your center caps properly may result in a shorter life for your emblem insert overlays.
Carefully Remove Decal Paper Back
Very carefully remove the decal from the paper back it arrives on. Make sure to do this slowly. Going too quickly or roughly can stretch the vinyl.
MAKE SURE your hands are dry when removing the vinyl decal from the paper.
DO NOT get the back paper wet. Doing so will cause the paper to stick to the decal and ruin the overlay.
Align Decal Over Emblem
Take your time, carefully align the decal onto the center of the center cap.
The decal is designed to go slightly outside the yellow area and cover a bit of the surrounding silver area. This is to make it easier to install.
Press Into Place
After you have aligned your decal correctly, begin to press the decal into the center cap. Start from the inner areas of the decal and work your way outward.
Note: Make sure to use a link-free cloth to avoid any link sticking to the decal.
Enjoy Your New Look
You are done, it's that easy! Enjoy your new center cap decals for your Chevy!
